Setting Of Each Item - Sharp AN-LS1 Operation Manual

Setting of Each Item

The setting procedure for each item will be explained. For the basic procedure, please refer to
15.
IP Address Setting ([1]IP Address)
Setting of IP address.
setup>1
IP Address
Please Enter
(change)
Subnet Mask Setting ([2]Subnet Mask)
Setting subnet mask.
setup>2
Subnet Mask
Please Enter
(change)
Default Gateway Setting ([3]Default Gateway)
Setting default gateway.
setup>3
note: "0.0.0.0" means "Using no default gateway."
Gateway Address :0.0.0.0
Please Enter
(change)
If operations on this page are performed while changing the setting for AN-LS1 via Telnet, there may be
situations where AN-LS1 cannot be connected depending on the network setting for the computer for control
since the set values for IP Address, Subnet Mask or Gateway are restored to the initial state.
:192.168.150.2
:192.168.150.3
—> 192.168.150.3
:255.255.255.0
:255.0.0.0
—> 255.0.0.0
:192.168.150.1
—> 192.168.150.1
18
Enter "1" and press the return key.
Enter numerical value to be set
and press the return key.
Display IP address after
change.
Enter "2" and press the return key.
Enter numerical value to be set
and press the return key.
Display subnet mask after
change.
Enter "3" and press the return key.
Enter numerical value to be set
and press the return key.
Display gateway address after
change.
page