Repair Instructions; Dismantling The Starter - RedMax GZ5000 Workshop Manual

Hide thumbs Also See for GZ5000:

Table of Contents

Loosen the four screws, which hold the starter

against the crankcase and remove the starter. See

figure 1a

Pull the cord out about 30 cm and lift it into the

notch on the outside of the starter pulley. Release

the tension in the return spring by letting the starter

pulley rotate anti-clockwise. See figures 1b and 2.

WARNING!

If the spring tension is activated

on the starter pulley, the spring

can fly out and cause personal

injury. Wear protective glasses.

Remove the clip in the centre of the pulley. Remove

the spacer and the pulley. See figure 3. Loosen the

screws on the cassette and remove the cassette

and spring.

Cleaning and inspection

Clean the parts and check:

•

The starter cord.

•

That the starter pawls on the flywheel are intact,

i.e. that they spring back to the centre and

move easily.

•

To lubricate the return spring using light oil.

7 Repair instructions

Fig 1a

Fig 1b

Fig 2

Fig 3

Repair Instructions

English -

Table of Contents

Table of Contents