Repair Instructions; Dismantling The Starter - RedMax GZ4350 Workshop Manual

Hide thumbs Also See for GZ4350:

Table of Contents

WARNING!

If the spring tension is activated

on the starter pulley, the spring

can fly out and cause personal

injury. Wear protective glasses.

Loosen the three screws, which hold the starter

against the crankcase and remove the starter. See

figure 1.

Pull the cord out about 30 cm and lift it into the

notch on the outside of the starter pulley. Release

the tension in the return spring by letting the starter

pulley rotate anticlockwise. See figures 2 and 3.

Make sure the starter pulley is not tensioned.

Loosen the screw in the centre of the pulley and

remove the sprocket. See figure 4.

Cleaning and inspection

Clean the parts and check:

•

The starter cord.

•

That the starter pawls on the flywheel are intact,

i.e. that they spring back to the centre and

move easily.

•

To lubricate the return spring using light oil.

7 Repair instructions

Fig 1

Fig 2

Fig 3

Fig 4

Repair Instructions

English -

Table of Contents

Table of Contents