Vibration Damping System - RedMax GZ5000 Workshop Manual

Assembly
1. Thread the throttle cables in the connection K
as outlined in figure 57. NOTE! The figure is
shown from underneath.
2. Run the fuel hose C through hole I and hoses B
in hole J. See figure 57. Pull the hoses so that
the collars are on each side of the bottom on
the carburettor compartment.
3. Tighten the chain catcher in place.
4. Press the movement limiter G into position. See
figure 55.
5. Tighten the screws E. See figure 53.
6. Hook on the throttle cable D in the intake bellow.
See figure 52.
7. Fit the tank unit. The two short screws are fitted
to the bottom of the handle bar.
8. Assemble the carburettor as outlined in "Assem-
bling the carburettor". Assemble the air filter
and cylinder cover.

7.17 Vibration damping system

Dismantling
1. Dismantle the following parts:
• Bar and chain. See the Operator's Manual.
• Cylinder cover. See the Operator's Manual.
• Tank unit and handle. See "Dismantling the
tank unit".
2. Dismantle the spring on the handle bar using a
4 mm Allen key (see figure 59).
3. Dismantle the springs on the tank unit using
a 4 mm Allen key (tool 502 50 18-01). See
figure 59.
Cleaning and inspection
Clean and inspect all parts.
Assembly
1. Fit the springs on the handle bar using a 4 mm
Allen key (tool 502 50 18-01).
2. Assemble the following parts:
• Tank unit and handle. See "Assembling the
tank unit".
• Cylinder cover. See the Operator's Manual.
• Bar and chain. See the Operator's Manual.
Fig 56
K
J
Fig 57
B
C
Fig 58
Fig 59
Repair Instructions
H
I
D
49
English -