Electrical Connection - Electrolux EWN 148640 W User Manual

28 electrolux
4. Connect the hose to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be posi-
tioned in three ways.
• Hooked over the edge of a sink using
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the ma-
The drain hose may be extended to a maximum of 4 metres. An additional drain hose
and joining piece is available from your local Service Centre.

ELECTRICAL CONNECTION

Information on the electrical connection is
given on the rating plate on the inner edge
of the appliance door.
Downloaded From WashingMachine-Manual.com Manuals
chine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
• In a sink drain pipe branch. This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
• Directly into a drain pipe at a height of
not less than 60 cm and not more than
90 cm. The end of the drain hose must al-
ways be ventilated, i.e. the inside diame-
ter of the drain pipe must be larger than
the outside diameter of the drain hose.
The drain hose must not be kinked.
Check that your domestic electrical installa-
tion can take the maximum load required, al-
so taking into account any other appliances
in use.