What To Do If - Electrolux EWC 1350 User Manual

Hide thumbs Also See for EWC 1350:
Table of Contents

Advertisement

Available languages

Available languages

14 electrolux
2. To remove the siphon at the inside
edge of the drawer for cleaning, you
need to press it inwards and pull it up-
wards at the same time. Flush it out un-
der a tap, to remove any traces of ac-
cumulated powder. When you put it
back, press it downwards until you
hear a distinct click.
CLEANING THE DRAWER RECESS
Having removed the drawer, use a small
brush to clean the recess, ensuring that all
washing powder residue is removed from
the upper and lower part of the recess.
Replace the drawer and run the rinse pro-
gramme without any clothes in the drum.
CLEANING THE WATER INLET FILTER
If your water is very hard or contains traces
of lime deposit, the water inlet filter may be-
come clogged. It is therefore a good idea to
clean it from time to time.

WHAT TO DO IF...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
Turn off the water tap. Unscrew the water
inlet hose. Clean the filter using a hard bris-
tle brush. Tighten up the inlet hose.
THE DANGERS OF FREEZING
If the machine is exposed to temperatures
below 0°C, certain precautions should be
taken.
• Turn off the water supply.
• Unscrew the inlet hose from the supply
tap.
• Select a wash programme, start the ma-
chine and let the programme run for a
short time.
• Interrupt the programme by turning the
programme selector to
• Place the end of inlet and drain hoses
down low, into the waste gully (floor
drain) set into the floor. Make sure that
the end of the hose does not go below
the water level in the gully's (drain's) wa-
ter tap.
• Select the programme "Drain" and let it
run until it is finished.
• Turn the programme selector to
position. When you intend to start the
machine up again, make sure that the
room temperature is above 0 °C.
The appliance is only to be used and stored
indoors at normal room temperature. The
manufacturer is not responsible for any
frost damage.
During machine operation it is possible that
the End pilot light blinks to indicate that the
machine is not working:
• 1 flash: problem with the water supply.
• 2 flashes: problem with the water drain-
ing.
position.

Advertisement

Chapters

Table of Contents
loading

Table of Contents