What To Do If - Electrolux EWC 1050 User Manual

14 electrolux
Turn off the water tap. Unscrew the water
inlet hose. Clean the filter using a hard bris-
tle brush. Tighten up the inlet hose.
The dangers of freezing
If the machine is exposed to temperatures
below 0°C, certain precautions should be
taken.

WHAT TO DO IF...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the End pilot light blinks to indicate that the
machine is not working:
Problem
The machine does not start:
• Turn off the water supply.
• Unscrew the inlet hose from the supply
• Select a wash programme, start the ma-
• Interrupt the programme by turning the
• Place the end of inlet and drain hoses
• Select the programme "Drain" and let it
• Turn the programme selector to
The appliance is only to be used and stored
indoors at normal room temperature. The
manufacturer is not responsible for any
frost damage.
• 1 flash: problem with the water supply.
• 2 flashes: problem with the water drain-
• 4 flashes: door open.
Once the problem has been eliminated,
press the button START to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Centre.
Possible cause/Solution
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button Start
has not been pressed.
• Please turn the selector dial and press the button Start again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay
start.
tap.
chine and let the programme run for a
short time.
programme selector to
down low, into the waste gully (floor
drain) set into the floor. Make sure that
the end of the hose does not go below
the water level in the gully's (drain's) wa-
ter tap.
run until it is finished.
tion. When you intend to start the ma-
chine up again, make sure that the room
temperature is above 0 °C.
ing.
position.
posi-