Toshiba MMU-UP0051MH-E(TR) Service Manual page 185

No. Part name
PMV coil 1. Detachment
(1) Carry out the works items
(2) Cut the binding bands (2 places) to remove the tube
of the relay part of PMV.
(3) Remove the PMV lead from the relay connector
(4) Turn the PMV coil slightly clockwise while holding the
PMV body so that the body does not turn, and remove
it in the arrow direction.
2. Attachment
(1) Attach the PMV coil as before and check it does not
move.
NOTE
• Check the direction of the PMV coil.
• Check the claw holes in the PMV coil are securely placed
into four claws on the PMV body.
• Check position of the lock part on the binding band and
the lead wires.
(2) Connect the PMV lead wire to the relay connector of
PMV.
(3) Attach the tube as before and fix it with the binding
band (2 place).
Procedure
-1.
Lead wire
(with protective tube)
Binding band
Ensure that the lock part on the binding
band comes to the position in the figure.
– 185 –
Remarks
Tube Tube Tube
Heat exchanger
Relay connector
part of PMV
PMV coil
Work while holding Work while holding Work while holding
the PMV body with the PMV body with the PMV body with
Turn the PMV coil your hand. your hand. your hand.
counterclockwise
View A
Attach the PMV coil to the PMV body
so that the PMV coil protrusion part
points to the PMV body inlet.
Fit the claw holes on the PMV coil into
four claws on the PMV body.
PMV body inlet
Caution when fixing the lead wire with the
binding band.
. Do not apply tension to the drawing
part on the coil lead wire.
. Insert the protective tube up to the
root of drawing part on the lead wire.
. Ensure that the PMV pipe does not
come to contact with the protective tube.
View A
Binding band Binding band Binding band
(2 places) (2 places) (2 places)