Toshiba MMU-UP0051MH-E(TR) Service Manual page 152

No. Part name
1. Detachment (In case of UP009)
Drain pan
1) Perform work Detachment 1 of
Perform work Detachment 1 of
2) Take off the drain cap and then extract accumulated
drain water in the drain pan.
Note
When taking off the drain cap, be sure to receive drain
water in a bucket, etc.
3) Remove the bell mouth followed to work of
Detachment 1 of
motor.
4) Remove the fan motor wiring from clamp on the
partition board.
5) Take off screw (M 4 × 8, 1 pc.) which fixes the partition
board and then remove it as if lifting up it.
6) Take off screws at 4 corners (M 4 × 8, 4 pcs.) which fix
the drain pan and then pull out the drain pan quietly.
2. Attachment (In case of UP009)
1) Attach the drain pan as original while passing the fan
motor wiring and the drain pump/ sensor wiring
through the specified hole.
Note
Be sure to pass the drain pump sensor wiring through the
specified fixing slit of the inner foaming.
Be sure to pass also the fan motor wiring through the
clamp and the fixing slit.
2) Attach all the partition board, bell mouth, electric parts
box, ceiling panel, air filter and center panel as
original.
For wiring in the electric parts box, be sure to wire it
as original.
Procedure
.
.
and release fixing of the fan
– 152 –
Remarks
Fan motor
wire
In case of UP009
Screw Screw Screw
Bell mouth
Fan motor wiring Fan motor wiring Fan motor wiring
fixing slit fixing slit fixing slit
Fan motor wire Fan motor wire Fan motor wire
Clamp Clamp Clamp
Screw Screw Screw
Partition board Partition board Partition board
Screw
Screw
Drain pump/sensor wiring fixing slit
Drain pump/ Drain pump/ Drain pump/
sensor wiring sensor wiring sensor wiring
Inner foaming Inner foaming Inner foaming
Drain pan
Drain cap