Table of Contents
Advertisement
Maintenance
Repair must only be carried out by a
GERIMA trained technician!
Improperly repaired machines are
hazzard!
•
Increased risk of injury
•
Machine does not function correctly!
Hot carbide inserts and milling head!
•
Burn hazzard!
•
Wear protective gloves when replacing
the carbide inserts!
Maintenance plan:
Part to be serviced
Gear box
re-grease approx. every
1
Motor laminations
2
Height adjuster
3
thread
Carbide inserts
Service 1:
Open screw (arrow) and max. Top up with 17ml of
lubricant. The normal consumption is approx. 10 ml /
1,000 operating hours. Approx. 0.25 ml are filled up per
actuation of the grease gun.
Service 2:
A slat replacement should only be certified by one.
GERIMA service or Atlas Copco service are carried out,
otherwise the guarantee claims will be lost.
Disposal of components removed from the machine
All machine parts and operating and auxiliary materials must be disposed of in accordance
with the applicable statutory provisions.
©
Before servicing the
machine always must be
disconnected from the
compressed air supply and
secured against
reconnection.
Type of maintenance
work
certified GERIMA
1000 operating hours
service agent
replace as
certified GERIMA
necessary
service agent
clean and lubricate as
trained technician disassemble guide
necessary
rotate or replace as
machine operator
necessary
Blunt tool can cause damage!
•
•
•
Service
Maintenance
procedure
disassemble
gear box
stave replace
plate unit
see page
15
Service 3:
Unscrew the guide plate, unscrew the guide plate holder,
clean the thread, spray with teflon spray and reinstall.
Maintenance
Blunt tool can overload the machine!
Inspect milling tools regulary for signs of
wear.
Wear protective gloves when changing
or readjusting the carbide inserts!
1
2
3
Materials
required
lubrication
0109.007.10-00002
greaset
stave-set
0109.113.09-00029
teflon pray
0109.007.10-00005
torx-key T15
Order-nr.
see page
17
19
Advertisement
Table of Contents
