Table of Contents
Advertisement
Modifications to the machine:
The machine may not be modifi-
ed, added to or converted unless
the prior consent of the manufac-
turer has been granted.
Any alterations to the machine
must have been approved by
GERIMA GmbH.
This also applies to the welding of
the component parts.
Cleaning the machine and disposal information:
All substances and materials used
must be handled appropriately and
accordance with all relevant statuto-
ry provisions and legislation.
The machine must only be cleaned
after it has been switched off!
Machine noise:
The continuous sound power level emitted by the
machine at the installation site is greater than > 84
dB (A).
Operating personnel must wear ear
protection!
©
Basic safety instructions
Residual risks:
• The machine was plant and constructed with all
suitable devices to guarantee the safety and
health of the operator.
• The machine is covered to prevent the risk of
contact with moving parts.
• However residual risks still exist.
• As already mentioned the cutting area is protected
as far as possible but there is an opening portion
through which the processing material must be
introduced.
• It is possible that the operator reaches in this area
with his hands.
Always keep your hands as far as
possible away from the cutting area!
Always oberserve the safety rules to
minimize the residual risks!
Be aware that the machine may be a
source of residual mechanical or
pneumatically energy. Appropriate
precautions for dealing with these
hazardous energy sources must be
taken when instructing operating
personnel on the use of the machi-
ne.
13
Advertisement
Table of Contents
