Table of Contents
Advertisement
12. Carefully slide the Upright Crossbar (58)
between the Left and Right Uprights (89, 90).
Attach the Upright Crossbar with the four 5/16" x
3/4" Screws (31) that you removed in step 5
and four 5/16" Star Washers (11); start all four
Screws, and then tighten them.
13. Note: If the treadmill is assembled on a
smooth surface, it may roll forward during
this step.
Raise the Frame (56) to the upright position.
IMPORTANT: Do not raise the Frame past the
vertical position. Have a second person hold
the Frame until step 15 is completed.
Remove the two 5/16" x 3/4" Patch Screws (25)
from the Latch Crossbar (38).
Then, orient the Latch Crossbar (38) as shown.
Make sure that the "This side toward belt"
sticker (I) is facing the treadmill. Attach the
Latch Crossbar to the brackets (J) on the Frame
(56) with the two 5/16" x 3/4" Patch Screws (25)
and two 5/16" Star Washers (11).
12
90
31
11
13
J
11
25
56
13
89
58
31
11
I
38
J
11
25
Advertisement
Table of Contents
