Lubricating The Gears; Storage; Transport; Waste Disposal And Environmental Protection - Parkside PGKGA 40-Li B2 Translation Of The Original Instructions

1. Fold the thread in the middle and
place the middle of the thread in the
notch (59) of the spool (17).
Wind up the two ends in the direction
of the arrow, which is shown on the
topside of the spool
2. Then clamp the end of each thread in one
of the grooves (60) on the spool (17).

Lubricating the gears

The gear units of the attachments require lubri-
cation after around 10 hours of operation.
Pole pruner
1. Use the lubricating nipple (62) to press
up to 5 g of standard grease into the
gearbox housing with a grease gun.
Trimmer/brush cutter
1. Release the screw (63) on the gears.
2. Insert up to 5 g of commercially-avai-
lable lubricating grease into the lubrica-
tion opening on the gearbox housing.
3. Close the gears again using the screw
(63).

Storage

Perform cleaning and maintenance
work before storage.
• Store the device in the transport pro-
9/10) provided in a dry
tection (
A
location and out of reach of children.
Store the appliance in horizontal posi-
tion or secured against toppling over.
• Store the 3-tooth blade (
supplied transport protection (
attached.
• For storage, you can hang the unit at
the bottom of the motor unit.
•
•
•
.
•
•

Transport

• Always use the protective
• Always carry the device with the cut-
• Only when used with the hedge trimmer
Waste Disposal
and Environmental
Protection
Remove the batteries from the device and
recycle the device, battery, accessories
and packaging in an environmentally-
12) with the
A
13) friendly manner.
A
Do not dispose of waste oil in the sewer or
your drain system. Dispose of waste oil in
an environmentally friendly way - take it to
your local recycling centre.
Empty the oil tank if it will not be used
for a prolonged period of time (6-8
weeks).
Clean the device and accessories ca-
refully before storage.
Store the device in a dry and dustproof
location and out of reach of children.
Do not wrap the device in plastic bags
as moisture and mildew may form.
Do not lie the device down on the
protective cover.
Never transport your appli-
ance while the appliance is
turned on! Risk of injury!
cover (
9/10) when transporting.
A
ting unit pointing backwards using both
hands: one on the rear handle and the
other on the front round handle (
attachment:Put the cutter bar in transport
position (see "Swivelling out the cutter
bar") and clip the tube shaft into the
transport clip (10a) on the transport pro-
tection, cutter bar (10).
GB MT
5).
A
69