Table of Contents
Advertisement
Installation Instructions
After Unpacking and locating the machine to it's operation area;
Water & Waste Connections (local regulations apply).
Both the
cold
water and
hoses. These have standard European washing machine fittings (3/4" threaded connections) and must
have a 3 bar pressure (±0.5 bar) water supply. High water pressure & temperature could prevent the unit
working.
Water connections should be located within 1 meter of the installation location prior to final positioning
of the machine.
Hot water
temperature between 30-50°C.
The waste connection is a standard 2" or ∅63mm pipe fitting. We suggest using a rubber straight
connector between the WasteStation and the site plumbing fittings. This will avoid any issues between
types of fittings used.
The size of the product outlet must not be reduced, the drainpipe should run into 54mm outside
diameter pipe work as far as its junction with the main pipe or outside manhole connection. The length
of run between the machine and the main junction must be kept to a minimum and the pipe run must
have a fall of at least 1° fall.
A running trap should be fitted, although "P" or "S" type traps
should not be used . Do not use bottle traps. Changes of direction
should be made by swept bends not elbows and cleaning eyes
should be fitted where possible, in accordance with standard
plumbing practice.
Copper pipe and compression fittings should be used, but plastic tubing is acceptable to most drainage
authorities.
The WasteStations must have an independent waste pipe,
dishwashers and similar equipment.
Ensure the foot mechanism is
lowered into the correct position
ensuring the WasteStation wheels
are not in contact with the floor and
the unit cannot move.
hot
water connections are colour coded and come with colour coded water
suppliers need to be supplied via a braked tank and supplied at a
Cold water
supply dependant on model purchased.
which does not also serve sinks,
Ecofast Environmental UK Ltd
5
Advertisement
Table of Contents
