Ý (Easy Iron); L (Rinse Plus); Z (Water Plus); Â (Memory) - Siemens WD4HU540ES Instruction Manual And Installation Instructions

Ý (Easy iron)
Reduces creasing by means of a
special spin sequence followed by
fluffing and reduced spin speed.
Touch Ý (Easy iron) and activate or
deactivate it.
If Ý (Easy iron) has been
Note:
activated, the laundry will have retained
a higher than average level of moisture
after spinning.

l (Rinse plus)

Additional rinse cycle depending on the
programme; longer programme length
for particularly sensitive skin and/or for
areas with very soft water.

z (Water plus)

Increased water level for gentler
treatment of the laundry.
Touch z (Water plus) to activate or
deactivate it.
â (Memory)
With memory you can save a selected
programme with your favourite settings.
To store:
Switch on the appliance.
1.
Select a programme.
2.
If required, change the programme
3.
default settings and/or select
programme additional settings.
Touch and hold â (Memory) button
4.
for approx. three seconds.
The programme is saved if all of the
settings flash briefly.
Calling up: touch â (Memory) button
briefly after you switch on the appliance.
Reset: touch and hold â (Memory)
button again for approx. three seconds
after selecting the new programme and
settings.
Additional programme settings
ç (Silent)
Function designed for noise reduction.
Washing and drying process noise will
be reduced, and ending signal will be
switched off.
If silent is selected for wash only,
Note:
remaining moisture of the laundry will
be slightly increased. The spin result
may not be satisfying. Before hanging
you can select 0 programme to further
reduce moisture.

} (Remote start)

Touching } (Remote start) allows you
to start the programme remotely via the
Home Connect app or to call up the
Home Connect settings.
Enabling the programme to be started
remotely via the Home Connect app:
Remote start can only be
Note:
activated if the appliance door is closed
and the appliance is connected to your
home network.
Briefly touch } (Remote start).
■
Remote start will be
Note:
deactivated for safety reasons in the
following circumstances:
You open the door.
There is a power failure.
Once the programme has ended.
If you touch I on the appliance.
If you briefly touch } (Remote
start) again.
If you press # to switch off the
appliance.
Calling up Home Connect settings:
Touch and hold } (Remote start) for
■
at least 3 seconds.
en
35