Operating the appliance
en
l (Rinse plus)
Additional rinse cycle depending on the
programme; longer programme length
for particularly sensitive skin and/or for
areas with very soft water.
Ý (Easy iron)
Reduces creasing by means of a
special spin sequence followed by
fluffing and reduced spin speed.
Touch Ý (Easy iron) and activate or
deactivate it.
If Ý (Easy iron) has been
Note:
activated, the laundry will have retained
a higher than average level of moisture
after spinning.
z (Water plus)
Increased water level for gentler
treatment of the laundry.
Touch z (Water plus) to activate or
deactivate it.
â (Memory)
You can save a selected programme
with your favourite settings here.
To store:
Switch on the appliance.
1.
Select a programme.
2.
If required, change the programme
3.
default settings and/or select
programme additional settings.
Touch and hold â (Memory) button
4.
for approx. three seconds.
The programme is saved if all of the
settings flash briefly.
Calling up: touch â (Memory) button
briefly after you switch on the appliance.
Reset: touch and hold â (Memory)
button again for approx. three seconds
after selecting the new programme and
settings.
34
ç (Silent)
Special designed function for noise
reduction. Washing and drying process
noise will be reduced, and ending
signal will be switched off.
If silent is selected for wash only,
Note:
remaining moisture of the laundry will
be slightly increased. The spin result
may not be satisfying. Before hanging
you can select 0 programme to further
reduce moisture.
1
Operating the
appliance
T he appliance was tested before
O p e r a t i n g t h e a p p l i a n c e
delivery. To remove residual water from
the test procedure, the first wash cycle
should be run without laundry using the
limp. tambor (Drum Clean) programme.
~ "Before washing for the first time"
on page 20
Notes
Never switch on a damaged
■
appliance!
Inform customer service!
■
Insert mains plug.
1.
:
Warning
Risk of death from electric shock!
Risk of death if live parts are
touched.
– Never pull out the mains plug by
tugging the power cord.
– Insert/pull out the mains plug
with dry hands only.