Power To Copier - Sharp AL-800 Operation Manual

Paper guide
Make sure the paper release lever is pushed back. The paper will be clamped by the
4
paper feed roller inside the copier.
When placing special paper or several sheets of paper or when making two-
sided copies, the paper may not be clamped inside the copier even if the paper
release lever is pushed back. In this case, repeat the paper release lever
operation several times to make sure that the paper is clamped.

POWER TO COPIER

Ensure that the power switch of the copier is in the OFF position. Insert the attached
1
power cord into the power cord socket at the rear of the copier.
If you use the copier in a country other than the country where the copier was
purchased, you will need to make sure that the local power supply is compatible
with your model. If you plug the copier into an incompatible power supply,
irreparable damage to the copier will result.
Side to be
printed
LOADING COPY PAPER
Paper support
2
15