Status Indicators; Displaying Total Number Of Copies - Sharp AL-800 Operation Manual

STATUS INDICATORS

When any of following indicators light up or blink on the operation panel or the following
alphanumeric codes appear in the display, solve the problem by referring to both the table
below and the relevant page.
Be sure to use only genuine SHARP parts and supplies.
Indication
Drum replacement
required indicator
TD cartridge
replacement
required indicator
Misfeed indicator
"CH" is blinking in the display.
"CH" is steadily lit in the
display.
"P" is blinking in the display.
A letter and a number appear
alternately.

DISPLAYING TOTAL NUMBER OF COPIES

Use the following procedure to display the total number of copies.
Press the clear (
1
Press and hold down the clear (
2
of copies will appear in two steps, each with three digits.
Example: Total number of copies is 1,234.
Cause and remedy
Steadily Replacement of drum cartridge will be needed
lit soon. Obtain a new cartridge.
Drum cartridge must be replaced. Replace it
Blinking
with a new one.
Replacement of TD cartridge will be needed
Steadily
soon. Obtain a new cartridge.
lit
TD cartridge must be replaced. Replace it with
Blinking
a new one.
A misfeed has occurred. Remove the misfed
Blinking
paper referring to the description of "Misfeed
removal."
The TD cartridge is not installed. Check if the
cartridge is installed.
Front cover is open. Close the front cover
securely.
Paper tray is empty. Load copy paper.
A misfeed has occurred in the paper tray.
Remove the misfed paper.
The copier will not function. Turn the power
switch off, remove the power cord from the
outlet, and contact your SHARP service
center.
) key to reset the display to zero.
) key for approximately 5 seconds. The total number
See
page:
44
29
44
28
34
6
28
–
14
34
–
41