Loading Copy Paper (Installing The Paper Tray) - Sharp AL-800 Operation Manual

LOADING COPY PAPER (installing the paper tray)

Hold the paper tray so that the paper guide of the paper tray is facing front and then
1
insert the paper tray into the copier's paper tray slots.
2
Pull the paper release lever located at the back of the copier towards the front of the
2
copier.
For legal size paper, raise the paper support. Fan the copy paper and place it into the
3
paper tray with the side to be printed facing toward you. Position the paper along the
right side of the paper tray. Then adjust the paper guide to the paper width.
14
If the paper is inserted without doing this, paper misfeeds will occur.
The paper tray holds up to 250 sheets of standard paper (15 to 21 lbs.). Do
not set too many sheets.
Feed copy paper lengthwise only.
When copying onto special paper such as labels and transparency film, feed
one sheet at a time.
When copying onto an envelope, insert it so that the side to be printed on is
facing upwards and so that the flap on the reverse side is to the right when
looking from the front of the copier. Leave a gap of approximately 1/32" (1
mm) between the paper guide and the left edge of the envelope.
When loading an envelope, make sure that it is straight and flat.
Paper tray
Paper release lever
View from the
back of copier