Copier Trouble; Misfeed Removal; Misfeed In The Paper Tray - Sharp AL-800 Operation Manual

6
This chapter describes misfeed removal and troubleshooting.

MISFEED REMOVAL

When the misfeed (
of a misfeed. First check the misfeed location. Remove the misfed paper following the
instructions for each location shown in the illustration below.
If blinks in the display, proceed to "A. Misfeed in the paper tray". (p. 34)
6
If the misfed paper is seen from this side,
proceed to "C. Misfeed in the exit area".
(p. 36)
A. Misfeed in the paper tray
Pull the paper release lever at the right of the paper tray toward you.
1
Remove all the paper, including the jammed paper, from the paper tray.
2
34

COPIER TROUBLE?

) indicator blinks or
If the paper is misfed here, proceed to
"A. Misfeed in the paper tray". (p. 34)
If the misfed paper will not come out easily, do not pull it hard, as you may tear
it or damage the printing mechanism. In such cases, proceed to "B. Misfeed
in the copier" on page 35.
blinks in the display, the copier will stop because
If paper is misfed here, proceed to
"B. Misfeed in the copier". (p. 35)
Paper release lever