Transfer Charger; When Copier Is Not In Use - Sharp AL-1000 Operation Manual

Transfer charger

If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean the
charger using the following procedure.
Turn the power switch off.
1
Open the side cover while pressing the side cover open button.
2
Take the charger cleaner out by holding the tab.
3
Set the charger cleaner onto the transfer charger and gently slide the cleaner back
and forth two or three times.
Slide the charger cleaner from one end to the other end along the groove of
the transfer charger. If the cleaner is stopped on the way, smudges on copies
may occur.
Return the charger cleaner to its original position. Close the side cover by pressing
4
the round projections near the side cover open button.
Turn the power switch on.
5

When copier is not in use

To prevent entry of dust and foreign matter, store the copier as follows.
Remove the power cord and secure the copier using tape (two locations).
1
USER MAINTENANCE
5
29