Primary And Hepa Filter Disassembly And Replacement; Primary Filter Replacement; Hepa Filter Assembly Or Replacement - Nilfisk-Advance VHC200 EXP Instruction Manual

VHC200 / VHC200EXP
Primary and HEPA filter disassembly and
replacement
When the vacuum cleaner is used to vacuum
hazardous substances, the filters become
contaminated, therefore:
■ work with care and avoid spilling the vacuumed
dust and/or material;
■ place the disassembled and/or replaced filter in a
sealed plastic bag;
■ dispose of the filter in accordance with the laws
in force.
Filter replacement is a serious matter. The filter must
be replaced with one of identical characteristics,
filtering surface and category.
Otherwise the vacuum cleaner will not operate
correctly. Refer to HEPA warnings on page 8.

Primary filter replacement

Before proceeding with these operations, turn the vacuum
cleaner off and disconnect it from the pneumatic system.
■ Release the stop (1), unscrew the filter shaker knob (2).
■ Release the closing band (3).
■ Lift cap (4).
■ Lift filter (5) and unscrew the filter clamp (6) on bearing
ring (7).
■ Unscrew cage (8) and overturn the filter, exposing
coupling clamp (9).
■ Release the clamps and detach the cage from the filter.
■ Dispose of the filter according to local laws and
regulations.
■ Fit the new filter and secure it in the cage with special
clamps. Assemble the components in the reverse order
of disassembly.
Take care not to raise dust when this operation is
US
carried out. Wear a P3 mask and other protective
clothing plus protective gloves (DPI) suited to the
hazardous nature of the dust collected, refer to the
laws in force.
If necessary contact the manufacturer's Service Center.
C396
WARNING!
WARNING!
Figure 7
WARNING!

HEPA filter assembly or replacement

Do not attempt to clean the HEPA filter. Replace the
filter in necessary.
1. Cap
2. Closing band
3. Filter shaker stop
4. Filter shaker knob
5. Ringnut
6.
Disc
7. HEPA filter
8. Filter plate
Before proceeding with these operations, turn the vacuum
cleaner off and disconnect the pneumatic system.
Assembly
1. Release stop (3) and unscrew filter shaker knob (4),
release closing band (2) and remove cap (1).
2. Insert HEPA filter (7) and disc (6) on filter plate (8), then
tighten ringnut (5). Replace cap (1), lock it with closing
band (2) screw on filter shaker knob (4) and lock with
stop (3).
Replacement
1. Proceed as indicated in step 1 of the assembling
procedure.
2. Unscrew ringnut (5), and remove disc (6).
3.
Change filter (7) and replace the cap by proceeding in
the reverse order.
To dispose of the filter put it in a sealed plastic bag and
dispose of it in accordance with the laws in force.
10
WARNING!
Figure 8
03/2015