Cisco Nexus 9504 Hardware Installation Manual page 98

Removing a Fabric Module
1 Unscrew 2 captive screws (1 on each ejector handle).
b) Rotate the two handles at least 30 degrees so that the other end of each handle no longer holds the module in the slot.
See Callout 2 in the previous figure.
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of the slot. See
the following figure.
1 Pull on both handles to remove the fabric module
from the chassis.
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide
88
Replacing or Installing Modules, Fan Trays, and Power Supplies
2 Rotate both ejector handles away from the front of
the fabric module.
3 Screw in the 2 captive screws (1 on each handle) to
the module. Tighten each of these screws to 8 in-lb
(0.9 N·m) of torque.