Table of Contents
Advertisement
RE3 UHF Wireless
ID
g
h
9.3
Installing batteries
–
–
–
9.4
RE3-BPT setup menu
Editing any of the following parameters locally on the transmitter is possible. These edits will
override the settings synchronized from the mated receiver. Additionally, any parameter value
changes made locally on the transmitter may be overwritten the next time the transmitter is
synced to the mated receiver if those parameters are selected in the receiver's sync
configuration.
NOTE: No local edits will be possible if the transmitter is in Keylock mode (lock icon
displayed). See unlocking instructions below.
NOTE: Press and hold SET for three seconds to enter parameter edit mode. The frequency in
millions will begin flashing. Once in parameter edit mode, pressing SET multiple times will
advance through the adjustable parameters one parameter per press. The press and hold of
SET to enter parameter edit mode counts as the first SET button press.
Function
Frequency setup
581.725
The three digits to the
left of the decimal are
in millions (MHz).
The three digits to the
right of the decimal
are in thousands
(kHz).
Group setup
Electro-Voice
Item
AutoOff
Mute icon
Gently press the sliding magnetic battery door latch (item 6 shown above) downward to
unlock, while at the same time rotating the hinged battery door (item 8 shown above)
downward to fully open the battery compartment.
Install two fresh, high quality AA alkaline batteries (or fully charged AA size NiMH
rechargeable cells) paying close attention to match the polarity markings (+ and -) on
each battery to the polarity markings (+ and -) on the battery contacts.
Rotate the hinged battery door upward until the compartment door latches shut. The
magnetic latch will lock the compartment door.
# of SET
button
presses
1
MHz
2
3
Description, usage, and notes
This icon indicates auto off is engaged. It begins flashing when
the transmitter is muted indicating the countdown to shutoff
has begun.
The display shows MUTE only when the transmitter is muted.
Millions
▲ Increases frequency in increments of 1 MHz per
press.
▼ Decreases frequency in increments of 1 MHz per
press.
Thousan
▲ Increases frequency in increments of 1 kHz per
ds
press.
▼ Decreases frequency in increments of 1 kHz per
press.
To save changes:
Press SET while thousands is flashing; SAVE is displayed /
returns to home screen.
G: #
▲ Increases the group number (1-8) in increments of
one.
User Manual
RE3-BPT bodypack transmitter | en
Result
02-2023 | 05 | F.01U.362.808
49
Advertisement
Table of Contents
