Table of Contents
Advertisement
1. INTENDED USE
1.1BRUSHCUTTER AND GRASS TRIMMER
Intended use
This machine can be used as a trimmer with the cutting edge, and as a brushcutter with the cutting blade.
The grass trimmer must be strictly and only to cut grass or weeds that are not too dense. The brush cutter
must be used to cut hard grass, more dense weeds and small branches with a maximum diameter of 10mm.
Improper use
This machine is not intended to cut bushes or others similar plants requiring the tool to get off the ground.
Do not use this tool to work other materials such as stones, clay soils, etc.
.
1.2 MOUNTED POLE PRUNER
Intended use / improper use
The pole pruner is exclusively intended for pruning trees and/or cutting small wood from the ground. Any
other use is considered improper and will damage the tool.
The correct use also includes reading and observing the instructions for use at each use as well as
observing the warnings fixed on the machine. Before and during use, it is imperative to check the blade to
ensure that there is no mechanical damage. In case of necessary repairs, please contact your specialist
dealer.
Only the use of spare parts approved by the manufacturer or original spare parts is permitted. If
unauthorized or non-original spare parts are used, the user is liable for consequential injury to persons or
property resulting in the manufacturer being deprived of all liability.
1.3 HEDGE TRIMMER
Intended Use
Your hedge trimmer is a device used by a person to trim hedges and shrubs by working with one or more
blades arranged linearly and back and forth. A potential hazard exists if the device is used for other
purposes. Improper handling of the hedge trimmer increases the risk of injury from blades. Only the use of
spare parts and accessories approved by the manufacturer is permitted.
2. SAFETY INSTRUCTIONS
2.1 SAFETY INSTRUCTIONS FOR BRUSHCUTTER AND GRASS
TRIMMER
Proper safety precautions must be observed. This unit must be handled carefully. DO NOT EXPOSE
YOURSELF OR OTHERS TO DANGER.
Follow these general rules. Do not permit others to use this machine unless they are thoroughly responsible
and have read, and understand the machine manual and are trained in its operation.
Always wear safety goggles for eye protection. Dress properly; do not wear loose clothing or jewellery that
could become caught in moving parts of the unit. Safe, sturdy, non-skid footwear should always be worn.
Long hair should be tied back. It is recommended that legs and feet be covered to protect from flying
debris during operation.
Protective equipment must always be wear during the operation of the tool, including at least hearing
protection, eyes protection, helmet, gloves, and mask of protection, slip-resistant foot protection, and
protective clothes.
Inspect the entire machine for loose parts (nuts, bolts, screws, etc.) and any damage. Repair or replace
as necessary before using the machine. DO NOT USE any attachment other than the ones
recommended by our company. Serious injury to the operator or bystanders could result as well as
damage to the machine. Ask advice to you dealer of manufacturer. Do not use cutting attachment such as
metal multi-piece pivoting chains and flail blades.
Secure the machine during transport to prevent loss of fuel, damage or injury; always install the
protection device on the blade, check the cap of the fuel tank, and do not transport the tool upside down.
03
Advertisement
Table of Contents
