Table of Contents
Advertisement
Place the chain guide so that the safety pin on the chain engages in the chain's teeth. Make sure that the
direction of movement of the cutting chain is correct. Install the chain guard and tighten the fastening screw.
Adjusting the chain tension
-
The chain must not have too much clearance, but it must be possible to lift the chain a few millimeters from
the guide rail.
Loosen the fixing screw.
Slightly lift the end of the chain guide
Check the cutting chain for ease of operation by turning it
manually.
Adjust the tension of the chain by means of the screw for
adjusting the tension of the chain (4) so that the chain can be
lifted a few millimeters from the center of the guide rail.
Secure the safety screw.
-
Installation of the harness
Hang the harness in its dedicated location on the tube. Adjust the size of the harness properly to have a
correct working position.
The shoulder strap is equipped with an emergency release mechanism. To detach the machine from
the shoulder strap in emergency situations, pull the rope to move away from the machine.
WARNING
Check the emergency release mechanism BEFORE operating the machine.
Be sure to hold the machine when operating the emergency release mechanism.
When holding the machine firmly with your right hand, press both sides of the belt buckle.
18
Advertisement
Table of Contents
