Hyundai HCOMBI25 Original Instructions Manual page 16

- Carter of protection (Brush cutter and grass trimmer)
- Remove the two screws from the carter of protection.
- On the tube of the brushcutter/grass trimmer, place the carter of protection on its support.
- Screw the carter of protection with the two screws.
3-theethes blade for brushcutter
-
- On the tube of the brushcutter/grass trimmer, insert a metal locking tool into the hole on the side of
the drive gear and on the tool drive.
- Remove cover bell and the holding nut from the shaft.
- Install, in the following order, on the shaft: the blade, the cover bell and then the holding nut.
- Remove the metal locking tool.
- To remove the metal blade, put a metal locking tool into the hole on the side of the drive gear and
on the tool drive. Unscrew the holding nut and then remove the cover bell and the blade.
- Cutting head for grass trimmer
- On the tube of the brushcutter/grass trimmer, insert a metal locking tool into the hole on the side of
the drive gear and on the tool drive.
- Remove cover bell and the holding nut from the shaft.
- Install and screw the nylon cutting head. Make that it is well installed.
- Remove then the metal locking tool.
- To remove the nylon cutting head, put a metal locking tool into the tool and then unscrew the nylon
cutting head.
- Hedge trimmer
- Install the bar of the main unit. Be sure that the locking pin is inserted in the hole of the bar
- Fix the bar by turning the nut anticlockwise.
16