Table of Contents
Advertisement
Filling the tank
a. Unscrew the tank cap. Place the tank cap in a clean, dust-free place.
b. Fill the tank to 80% of its capacity.
c. Screw the fuel cap back on. Clean the fuel tank cap and the area around after filling the fuel tank.
Eliminate overfill of fuel mixture by rubbing.
NOTE
When filling, avoid:
-
OIL-FREE FUEL (PURE FUEL) - This can quickly cause serious damage to the interior of the
engine components.
GASOHOL - may cause deformation of rubber or plastic parts and cause engine lubrication to
-
stop.
OIL FOR 4-TIME ENGINES - causes clogging of the spark plug, clogs the exhaust channel or
-
leads to seizure.
Fuel mixtures stored for more than one month may, if used, clog the carburetor and cause the engine to
malfunction.
If the unit is to be stored for an extended period of time, the tank must be cleaned after being emptied.
Leave the engine running to remove the remaining fuel from the carburetor.
Observe local regulations when disposing of used containers.
6. USE
6.1 STARTING THE 4-IN-1 MULTIFUNCTION TOOL
Do not start the appropriate module of the machine until all components have been connected correctly!
Attach the cutting blade of the brush cutter with a torque of 20 Nm and the cutting head of the mower with a
tightening torque of 15Nm.
WARNING: Fill the fuel tank before tightening the fuel tank cover.
-
Put the machine on a level, solid floor. Keep the cutting head away from the ground and away from
surrounding objects (Fig.5).
-
Press the priming bulb 5 to 8 times until fuel flows through the clear hose.
-
Position the choke in the closed position.
Set the ON/OFF switch to position "I". Make sure the cutting head is clear.
-
-
Keep the machine on the ground safely and then pull the starter until the engine
starts.
WARNING
The machine is equipped with a centrifugal clutch system.
When starting the engine, place the machine on a level, clean floor and hold it firmly to prevent the sharp
components or the throttle lever from coming into contact with any objects when the engine is started.
IMPORTANT
Avoid pulling the starter to the end or return the cable by suddenly releasing its handle. This can cause the
engine to fail.
Position the choke in the "open" position and restart the engine.
Let the engine warm up a few minutes before starting work.
20
Advertisement
Table of Contents
