Hyundai HCOMBI25 Original Instructions Manual page 21

NOTE
When restarting the engine directly after stopping it, keep the choke switch in the "open" position.

Overheating complicates engine starting due to overfilling of fuel. If the engine does not start after

several attempts, open the starter and press the starter several times, or remove and dry the spark plug.
6.2 STOP THE ENGINE
Release the throttle lever and let the engine run for about 30 seconds.

Set the ON/OFF switch to the 0 position.

IMPORTANT
Except in case of emergency, do not switch off the engine by pulling on the choke lever.
If the engine does not stop by pressing the stop switch, move the choke to the closed position.
6.3 USING THE GRASS TRIMMER
Be sure that you have installed the correct accessory.
- Trimming
Tilt the head slowly to direct debris away from you. If cutting up to a barrier such as fence, wall or tree,
approach from an angle where any debris ricocheting off the barrier will fly away from you, Move the line
head slowly until the grass is cut right up the barrier, but do not jam (overfeed) the line into the barrier. If
trimming up to a wire mesh or chain linked fence be careful to feed only up to wire. If you go too far the line
will snap off around the wire. Trimming can be done to cut through weed stems one at a time. Place the
trimmer line head near the bottom of the weed-never high up which could cause the weed to chatter and
catch the line. Rather than cut the weed right through, just use the very end of the line to wear through the
stem slowly.
- Scalping and edging
Both of these are done with the line head tilted at a steep angle Scalping is removing top growth leaving the
earth bear.
Edging is trimming the grass back where it has spread over a sidewalk or drive way. During both edging
and scalping, hold the unit a steep angle and in a position where the debris, and any dislodging dirt and
stones, will not come back towards you even if it ricochets off the hard surface. Although the picture shows
how to edge and scalp every operator must find for himself the angles which suits his body size and cutting
situation.
21