Cornelius 318569000 Installation Instructions

IMI CORNELIUS INC g One Cornelius Place g Anoka, MN 55303-6234
Telephone (800) 238-3600

INSTALLATION INSTRUCTIONS

DISPENSING VALVES KEYED LOCK-OUT SWITCH KIT (P/N 569000262)
Read and understand these instructions thoroughly before installing this Dispensing Valves Keyed Lock-out
Switch Kit (P/N 569000262) on the Post-Mix Dispensers. The purpose of the Keyed Lock-Out Switch is to shut
off electrical power to the dispensing valves to prevent dispensing of product. Retain these instructions as part
of your equipment manual.
LOOSE-SHIPPED PARTS
Note: Only qualified personnel should install this Kit.
Unpack and inspect kit. Make sure items are present and in good condition.
Item
No. Part No.
1 560003869 Wiring Harness
2 560003870 Template, Hole Drilling
3 318948000 Lock Key
4 318949000 Hex Nut
5 318569000 Key-Lock Switch
6 569000261 Installation Instructions
KIT INSTALLATION
WARNING: To avoid possible fatal electrical shock or serious injury to Installer, make sure
Dispenser is disconneced from power source before attempting to install this kit.
1. Disconnect electrical power from the Dispenser
2. Remove hood from the Dispenser, then lift hood straight up off the Dispenser for access to the transformer
on the refrigeration deck.
3. Refer to Figure 1 for location of hole to be drilled in the Dispenser hood for installation of the KEY-LOCK
SWITCH (item 5).
4. Place TEMPLATE, HOLE DRILLING (item 2) in position on Dispenser hood as shown in Figure 1.
5. Drill hole in Dispenser hood as indicated on the hole drilling template, then remove template from the hood.
EIMI Cornelius Inc; 1999–2003
ON
VANTAGE POST-MIX DISPENSERS
Table 1. Loose-Shipped Parts
Name
Facsimile (800) 535-4231
Qty
1
1
1
1
1
1
Revised: October 9, 2003
February 9, 1999
569000261