Table of Contents
Advertisement
Repair instructions
6.13 Replacing the pendulum shaft
bushings
Once the swing axle has been remove, the bushings
in the rear frame must be changed.
5
3
6
Remove the cover (1) on the right hand side. Loosen
the spring (2) with a spring hook. Loosen the screw
(3) and the cotter pin (4), then remove the belt
tensioner (5). Remove the bushings (6), one from
each direction.
535 41 32-02
The bushings must be initially lubricated with a
lithium-based grease. New bushings are fitted with
the mandrel, refer to "Special tools".
It is important that the outer bushing's outer edge is
on the same level as the beveled edge of the hole.
When the bushings are positioned, the belt tensioner
is fitted with the spring again.
30 – English
6.14 Replacing the bearings in the
articulation unit belt pulleys
6
2
1
4
1 Remove the articulated shaft with belt pulleys,
2 Remove the lock rings (3) holding the belt pulleys
3 Press the shaft (1) out from the belt pulleys (2).
4 Tap out the bearings (5) in the upper and lower
5 Press new bearings in using a bearing assembly
refer to "Replacing the Articulated Steering
Bearings", step 1 to 14.
(2) and the plastic cover (4) in the upper and
lower sections.
sections.
kit. Assemble in the reverse order.
3
5
2
5
4
3
1
Advertisement
Table of Contents
