Table of Contents
Advertisement
Repair instructions
2
1
9 Loosen belt 3 (cutting unit drive) from the tension
roller. Then pull it off from the center belt pulley,
then from the belt pulley of the articulated
steering.
10 Remove the rear attachments of both steering
cables.
11 Loosen the articulated shaft's screw from below.
28 – English
3
Loosen the two screws (4) using a half-inch
12 Use a slide hammer size M8 to loosen the
13 Separate the front and rear carriages.
4
5
wrench. Loosen the screw (5) behind the muffler
and the screw (6) holding the exhaust pipe. The
belt guide can now be removed.Jack up the front
IMPORTANT INFORMATION
When assembling, the gasket between the
muffler and the exhaust pipe must be replaced.
carriage in front of the cable pulley without
squeezing any cables. Jack up the rear carriage
in the rear edge.
articulated shaft and the belt pulleys.
4
6
Advertisement
Table of Contents
