INTRODUCTION Thank you for purchasing this CLARKE Worklight. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
1. ALWAYS check for damage before using the worklight. Inspect the power cable and plug for damage. Any damage should be properly repaired or the part replaced. Consult your local CLARKE dealer. 2. ALWAYS ensure that the voltage marked on the charger matches the power supply to be used.
ENVIRONMENTAL RECYCLING POLICY Through purchase of this product, the customer is taking on the obligation to deal with the WEEE in accordance with the WEEE regulations in relation to the treatment, recycling & recovery and environmentally sound disposal of the WEEE. In effect, this means that this product must not be disposed of with general household waste but according to the laws governing Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal facility.
OPERATION To switch on the different LEDs, press the ON/ OFF button in the following sequence. 1. The first press switches on the centre light. 2. The second press switches on the two upper and two lower LEDs. 3. The third press switches on all LEDs. 4.
COMPONENT PARTS Item Description Item Description Item Description Front Lens Switch Support Lithium Battery Housing Switch Cap Ratchet Reflector Radiator Back Pivot LED Plate Back Housing Hook Support Torch LED Sticker Back Housing LED Lens DC Hole Rubber Hook DC Socket Nut Front Pivot Screw DC Socket...
Need help?
Do you have a question about the MFL800R and is the answer not in the manual?
Questions and answers