Clarke GWL700R User Instructions

Clarke GWL700R User Instructions

Garage worklight

Advertisement

Quick Links

GARAGE WORKLIGHT
MODEL NO: GWL700R
PART NO: 4003541
USER INSTRUCTIONS
ORIGINAL INSTRUCTIONS
GC07/23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GWL700R and is the answer not in the manual?

Questions and answers

Summary of Contents for Clarke GWL700R

  • Page 1 GARAGE WORKLIGHT MODEL NO: GWL700R PART NO: 4003541 USER INSTRUCTIONS ORIGINAL INSTRUCTIONS GC07/23...
  • Page 2: Technical Specifications

    INTRODUCTION Thank you for purchasing this CLARKE worklight. Before attempting to use this worklight, please read this manual thoroughly and follow the instructions carefully. CONTENTS • Lamp unit • 100-240V Charger with USB port • Micro USB to USB charging cable...
  • Page 3: Safety Instructions

    1. ALWAYS check for damage before using the worklight. Inspect the power cable and plug for damage. Any damage should be properly repaired or the part replaced. Consult your local CLARKE dealer. 2. ALWAYS ensure that the voltage marked on the charger matches the power supply to be used.
  • Page 4: Environmental Recycling Policy

    ENVIRONMENTAL RECYCLING POLICY Through purchase of this worklight, the customer is taking on the obligation to deal with the WEEE in accordance with the WEEE regulations in relation to the treatment, recycling & recovery and environmentally sound disposal of the WEEE. In effect, this means that this worklight must not be disposed of with general household waste.
  • Page 5: Operation

    CHARGING THE WORKLIGHT IMPORTANT: Charge the worklight after each use or when the battery indicator light shows low. 1. Before charging, make sure the work light is turned off. 2. Connect the micro USB end of the charging cable to the micro USB port on the worklight the USB port on the wall charger.
  • Page 6: Component Parts

    COMPONENT PARTS EVA foam LED base Lens Magnet Battery support LED module-upper Screw Screw Housing-right Screw Housing connector Metal plate Screw Housing -left Lamp base connector USB housing Bolt Screw PCBA Hinge LED module support USB rubber Screw Li-ion battery Switch cap Aluminium body LED module base...
  • Page 7: Declarations Of Conformity

    DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...

This manual is also suitable for:

4003541

Table of Contents