Regulatory Information - DSC TL280LE-LAT Instruction Manual

Manual (72 pages)

Table of Contents

Modification Statement

DigitalSecurity Controlshas not approved anychanges or modifications to this device by the user. Anychanges or modifications could void the user's

authorityto operate the equipment. DigitalSecurityControls n'approuve aucune modification apportée à l'appareilpar l'utilisateur, quelle qu'en soit la

nature. Tout changement ou modification peuvent annuler le droit d'utilisation de l'appareilpar l'utilisateur.

Interference Statement

Thisdevice complieswith Part 15 of the FCC Rulesand Industry Canada licence-exempt RSSstandard(s). Operation issubject to the following two con-

ditions: (1) thisdevice maynot cause interference, and (2) this device must accept anyinterference, including interference that may cause undesired

operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareilsradio exempts de licence. L'exploitation est autorisée aux

deuxconditions suivantes: (1) l'appareil ne doit pasproduire de brouillage, et (2) l'utilisateur de l'appareildoit accepter tout brouillage radioélectrique

subi, même sile brouillage est susceptible d'en compromettre le fonctionnement.

Wireless Notice

Thisequipment complieswith FCC and IC radiation exposure limitsset forth for an uncontrolled environment. The antenna should be installed and oper-

ated with minimumdistance of 20 cm between the radiator and your body. Thistransmitter must not be co- located or operating in conjunction with any

other antenna or transmitter.

Cet appareilest conforme auxlimitesd'exposition auxrayonnementsde la IC pour un environnement non contrôlé. L'antenne doit être installé de façon

à garder une distance minimale de 20 centimètresentre la source de rayonnementset votre corps. L'émetteur ne doit pasêtre colocalisé ni fonctionner

conjointement avecà autre antenne ou autre émetteur.

Antenna gain must be below / Gain de l'antenne doit être ci-dessous:

Frequency Band/Bande de fréquence

GSM850 / FDD V

PCS1900 / FDD II

LTEB2

LTEB4

LTEB5 / B12 / B13

FCC Class B digital device notice

Thisequipment has been tested and found to complywith the limits for a ClassBdigital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmfulinterference in a residential installation. Thisequipment generates usesand can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference willnot occur in a particular installation. If thisequipment does cause harmfulinterference to radio or

television reception, which can be determined byturning the equipment off and on, the user isencouraged to tryto correct the interference byone or

more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different fromthat to which the receiver isconnected.

- Consult the dealer or an experienced radio/TVtechnician for help

CAN ICES-3 (B) / NMB-3 (B)

TL2803G(R)E -EU /3G2080(R)E- EU/TL280(R)E

FCC ID:F5316TL2803GRE

IC: 160A-TL2803GRE

Notes for EN50131-1:2006/A1:2009 Compliant installations:

ModelsTL2803G(R)E-EU/3G2080(R)E-EU/TL280(R)E/TL280LE-EU/LE2080-EU are an SPT Type Y. The module ismounted within CIEor PS housing

and it receivespower fromthe compatible CIEor Power Supplysource that are in compliance with EN50131-6:2017 Type Arequirementsfor a Grade 2,

ClassII application. This product hasno replacement partsand software programmable optionsare accessible at level3 (installer mode), section [851].

The TL2803G(R)E-EU/3G2080 (R)E-EU/TL280 (R)E/TL280LE- EU/LE2080-EU connectsto compatible DSC alarm controlpanelsusing the DSC pro-

prietaryserial interface and protocol PC-Link(converted also to RS- 422). The module operates in pass-through mode and it does acknowledge the

alarmto the compatible controlpanelafter an acknowledgement hasbeen received fromthe compatible alarmreceiver

1. The TL2803G(R)E-EU/3G2080(R)E-EU/TL280(R)E/TL280LE-EU/LE2080-EU module ismonitored bythe controlpaneland it isprogrammed via the

programming menu (* 8, section [851] in the control panel. The interface is connected to the PC- Link busas shown in the diagram included in this

manual.

2. The HSPA3G/LTECellular path isimmune to conducted and radiated RF fieldswith levelsup to 10V/mastested per EN50130- 4 Standard.

3. The TL2803G(R)E- EU/3G2080(R)E- EU/TL280(R)E/TL280LE- EU/LE2080-EU module conforms with radiated emissions levels for Class B equip-

ment asper standardsEN61000- 6-3/EN55022/CISPR32.

4. The TL2803G (R)E- EU/3G2080(R) E-EU/TL280 (R)E/ TL280LE- EU/LE2080-EU module uses AES128 encryption and heartbeat supervision for

HSPA3G LTE Cellular communication paths and it meets security levels S2 as per EN50136- 2:2013. It also uses authentication for each message

exchanged with the compatible receiver equipment at ARC and it meetsleveI 2 for information security.

5. The 3G2080 (R) E- EU/LE2080- EU module has only one communication path: HSPA3G or LTE Cellular communication path using

900/1800/2100MHzor LTE PublicCellular Network. The HSPA3G/LTE Cellular communication path that can be used in a standalone mode in con-

junction with a DSC alarmsystem(compatible DSC alarmcontrolpanelmodels: HS2128/064/032/016). The supported ATSconfiguration is: SP4.

6. The TL280(R)Emodule hasonlyone communication path: Ethernet communication path using Internet. The communication path that can be

used in a standalone mode in conjunction with a DSC alarmsystem(compatible DSC alarmcontrolpanelmodels: HS2128/064/032/016).

The supported ATSconfiguration is:SP4.

7. The TL2803G (R)E-EU/TL280LE-EU module hast wo communication paths: HSPA3G/LTECellular communication path using 900/1800/2100MHz

LTEPublic Cellular Networkand Ethernet communication path using Internet. The communication paths can be used in a standalone mode in con-

junction with a DSC alarm system (compatible DSC alarm control panel models: HS2128/064/032/016). The supported ATS configuration is:SP4 or

DP3.

8. TL2803G(R)E-EU/3G2080 (R)E-EU/TL280(R)E/ TL280LE-EU/LE2080-EU has been tested for compliance in conjunction with the following applic-

able standards: EN50136-1:2012 + A1:2018, EN50136- 2:2013, EN50131-10:2014, ATSconfiguration: SP4, DP3

For EN50131- 1:2006/A2:2017 compliant installations, the following programming optionsshallbe set asdescribed. Supervision Heartbeat: shallbe set

to 180 seconds