Programming Options - DSC TL280LE-LAT Instruction Manual

Hide thumbs Also See for TL280LE-LAT:

Manual (72 pages)

Table Of Contents

Table of Contents

[006] System Toggle Options 2

[1]- IPv6 control

ON - IPv4v6 Enabled. This option may be required by certain network providers. It is enabled at default in LTE com-

municators for LATAM, Europe and Australia

Off - IPv4 Only. This option is disabled at default in North American LTE communicators.

[5] - Radio Not In Use (v5.6+)ON - Radio Not In Use - The cellular radio will be disabled, preventing any trouble conditions

related to cellular from being indicated. This option applies to LATAM, European and Australian communicators and has

no effect in NA products. Enable this if no SIM card is being used with the communicator.

Off - Radio in Use

[7] DLS Over Cellular. Default (ON).

ON: DLS is enabled on the cellular path.

OFF: DLS is disabled on the cellular path.

NOTE: Program this toggle as OFF to prevent DLS from using the cellular path.

NOTE: If this toggle is OFF, DLS sessions will occur on the Ethernet path only, regardless of the primary path set in section

[005] toggle option [4]. If it is ON, the communicator will connect to the primary path first for DLS and if the session

fails, the secondary path will be used.

[8] Network Trouble Suppression. Default (OFF).

ON: GSM/Ethernet/Supervisory troubles and restore signals follow delay timer as programmed in section [226].

OFF: GSM/Ethernet/Supervisory troubles and restore signals are sent immediately.

[007] Primary Ethernet DNS IP

Default (000.000.000.000)

Enter the IP address for DNS server 1. Format is 4 fields, each field is a 3-digit decimal. Valid range: 000-255.

NOTE: If no value is programmed and DHCP is used, the DHCP server will configure the address. If an address is pro-

grammed and DHCP is used, the programmed address will be used instead of the DHCP address.

[008] Backup Ethernet DNS IP

Default (000.000.000.000)

Enter the IP address for DNS server 2. Format is 4 fields, each field is a 3-digit decimal. Valid range: 000-255.

NOTE: If no value is programmed and DHCP is used, the DHCP server will assign this value. If an address is programmed

and DHCP is used, the programmed address will be used instead of the DHCP address.

[009] Language

Default (01)

Opt

English

Spanish

Portuguese

French

Italian

Dutch

Polish

Czech

NOTE: Programming this section with an invalid language will default to English (01).

NOTE: After programming this section, perform a Default Language in section [999][11] to have programmable labels avail-

able in the selected language.