Table of Contents
Advertisement
3. Assembly
Assembling the trimmer :
2
1
Fit additional wheel :
5
4. Operation
RISK OF INJURY !
Connecting the trimmer :
8
9
7
1. Push the cover
2
behind
3
2. Push plant guard
until it locks into place.
The additional wheel is available as an optional extra for the
EasyCut 400. The additional wheel is already fitted on the
ComfortCut 450 / PowerCut 500.
Fit additional wheel :
v Fit additional wheel
guides of the handle holder
until you hear the connection
lock into place on both sides.
z
T
Remove additional wheel :
v Pull both catches
side and remove the additional
4
wheel
from the guides of the
handle holder
Fold additional wheel up / down :
4
v Press adjusting buttons
sides, fold additional wheel up / down
and release the adjustment buttons
Risk of injury if the Turbotrimmer does not switch off when
you release the start button.
V Never bypass the safety devices or switches (e.g. by
tying the safety lock to the handle).
1. Insert the loop of the extension cable
9
relief
from below through the upper part of the handle
and pull tight.
2. Plug the plug
extension cable
3. Plug the extension cable into a 230 V mains power supply.
0
A
3
into the guide of the cutting head from
until the connection locks into place on both sides.
1
onto the cutting head from the front
4
onto the
5
6
out to the
5
.
z
on both
T
0
of the trimmer into the socket
7
.
2
6
4
4
z
again.
T
7
into the cable strain
8
A
of the
13
Advertisement
Table of Contents
