Table of Contents
Advertisement
REMKO BL...DC
6
Installation
6.1 Installation of the indoor unit
The indoor unit is attached by means of a wall
bracket, taking into consideration the air outlet side
located in the lower part.
1.
Mark the mounting points on the structurally
permissible building sections according to the
dimensions of the wall bracket.
2.
If necessary, remove the break out opening
of the housing.
3.
Connect the refrigerant piping, electrical
cables and condensate drainage line to the
indoor unit as described below.
4.
Hang the indoor unit onto the wall bracket by
tilting it back slightly and by pressing the
bottom part of the unit against the bracket.
5.
Check again that the unit is level. (Fig. 31)
Fig. 31: Horizontal positioning
The wall bracket for the units must be attached
with suitable screws and anchors.
26
6.2 Connecting the
refrigerant piping
The refrigerant pipes should be connected by the
customer on the right-hand side of the outdoor
component.
1.
Use the wall or floor brackets to fit the out-
door unit against structural parts approved to
support the static load (refer to the installa-
tion instructions for the brackets).
2.
Ensure that structure-borne sound is not
transferred to parts of the building. Use vibra-
tion dampers to reduce the effects of struc-
ture-borne sound!
NOTICE!
Installation should only be performed by
authorised specialists.
CAUTION!
Both units are pre-filled with refrigerant at the
factory. Suitable protective clothing must be
worn during installation.
NOTICE!
Use only tools which are approved for use in
an HVAC environment.
Advertisement
Table of Contents
