Configuring Connection To The Internet; Lte Wan Connection - D-Link DVG-N5402G/ACF Quick Installation Manual

Wireless ac1200 dual band gigabit router with fiber wan port, 3g/lte support, 2 fxs ports, 1 pstn (lifeline) port, and usb port

Hide thumbs Also See for DVG-N5402G/ACF:

Table of Contents

DVG-N5402G/ACF

Configuring Connection to the Internet

You should configure your WAN connection in accordance with data

provided by your Internet service provider (ISP). Make sure that you

have obtained all necessary information prior to configuring your

connection. Otherwise contact your ISP.

If the PIN code check is enabled for the SIM card inserted into your LTE USB

modem, it is required to disable the PIN code check on the identification card

prior to connecting the USB modem to the router.

An active LTE WAN connection will be automatically created on the Net /

WAN page when connecting a USB modem to the router. If the connection has

not been created automatically, create a new connection manually.

For the USB modem Megafon M100-1, please reboot the router after

creating the WAN connection.

1. Go to the Net / WAN page and click the Add button.

2. In the General settings section, in the Provider drop-down list, leave

the Manually value.

3. From the Connection Type drop-down list, select the LTE value.

4. Make sure that the USB value is selected from the Interface drop-down

list.

5. Specify a name for your connection (any name for easier identification) in

the Name field.

4 Some models of LTE USB modems allow disabling the PIN code check in the web-

based interface of the router.

Quick Installation Guide

Table of Contents