Configuring Connection To The Internet - D-Link DIR-300NRU Quick Installation Manual

Wireless router with built-in 4-port switch

Hide thumbs Also See for DIR-300NRU:

Table of Contents

DIR-300NRU

Configuring Connection to the Internet

You should configure your WAN connection in accordance with data

provided by your Internet service provider (ISP). Make sure that you

have obtained all necessary information prior to configuring your

connection. Otherwise contact your ISP.

PPPoE or IPoE WAN Connection

1. Go to the Net / Connections page and select the WAN connection.

2. In the General settings section, select a needed value from the

Connection Type drop-down list.

3. In the Physical layer section, select the value corresponding to the

INTERNET port of the router (Ports:5) from the Physical interface

drop-down list.

4. If your ISP uses MAC address binding, enter the address registered by

your ISP upon concluding the agreement in the MAC field.

5. For Static IP connection (IPoE): fill in the IP Address, Netmask,

Gateway IP Address, and Primary DNS server fields.

6. For Dynamic IP connection (IPoE): select the Obtain an IP address

automatically and Obtain DNS server addresses automatically

checkboxes.

7. For PPPoE connection: enter authorization data provided by your ISP

(the username (login) in the PPP Username field and the password in

the Password and Password confirmation fields), or select the

Without authorization checkbox if authorization is not required.

8. If needed, fill in other fields on the page in accordance with data provided

by the ISP.

9. Click the Save button.

Quick Installation Guide

Table of Contents