Table of Contents
Advertisement
•
Do not attempt to clear snow from a gravel or crushed
rock surface. This product is intended for use only on
paved surfaces.
•
Do not use the machine on a roof.
•
Never attempt to make any adjustments while the engine
is running (except when specifically recommended by
manufacturer).
•
Stay alert for hidden hazards or traffic.
•
After striking a foreign object, shut off the engine,
remove the ignition key, thoroughly inspect the machine
for any damage, and repair the damage before starting
and operating the machine.
•
If the machine should start to vibrate abnormally, shut off
the engine and check immediately for the cause.
•
Do not run the engine indoors, except when starting
the engine and for transporting the machine in or out
of the building. Open the outside doors; exhaust fumes
are dangerous.
•
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
•
Never touch a hot engine or muffler.
Starting the Engine
1. Turn the ignition key clockwise to the O
(Figure
13).
2. Pull out the choke lever
position
N
Figure 13
(Figure 14
and
Figure
1. Choke lever
1. Symbols on the choke lever indicating to pull out the choke
lever to activate the choke
3. Firmly push in the primer with your thumb as indicated
by the table below, holding in the primer in for a second
before releasing it each time
Temperature
-23°C (-10°F) and above
Below -23°C (-10°F)
15).
Note: Remove your glove when you push in the
primer so that air cannot escape from the primer hole.
Important: Do not use the primer or the choke if
the engine has been running and is hot. Excessive
priming may flood the engine and prevent it from
starting.
4. Pull the recoil-start handle
8
Figure 14
Figure 15
(Figure
16).
Suggested Number of
Primes
3
6
Figure 16
(Figure
17).
Advertisement
Table of Contents
