Activating Programmable Leds; Setting Autoscroll Delay - ABB RELION 620 Series Operation Manual

Section 6
Operating procedures
6.4.2
6.4.3
98
A070922-ANSI V2 EN
Figure 75: Editing the setting group value
The active setting group is indicated with an asterisk * .

Activating programmable LEDs

1. Select Main menu/Configuration/Programmable LEDs.
2.
Select a programmable LED with
3.
Press to enter the selection and
4.
Change the mode with

Setting autoscroll delay

Autoscroll delay parameter sets the delay of scrolling down measurements view if it is set
as default view and the user is logged out. Autoscroll is active if the delay value is not zero.
1.
Select Main menu/Configuration/ HMI/Autoscroll delay and press
2.
Select delay time with
3.
Press to confirm the selection.
or .
to change the programmable LED mode.
or and press to confirm the selection.
or .
1MAC456939-IB D
.
620 series ANSI
Operation Manual