Installation - NEC Quadro K600 User Manual

1. Installation

This section describes how to install hardware and software. Installation procedure depends on whether
the other graphics accelerator is installed in your system or not. Follow the steps below to install
them appropriately to your system.
Even if Quadro K600 is already installed in your system, you need to install the display driver.
(1)If any graphics accelerator other than Quadro K600 is installed, be sure to uninstall other
display driver before installing Quadro K600.
When uninstalling display driver, restart the system and make sure that the system starts
normally.
※To uninstall the display driver, follow the steps below:
[Windows 7]
①
Select[Control Panel] → [Programs] → [Uninstall Programs]. (In Classic View, select [Control
Panel] → [Programs and Features].)
②
Select a driver you want to uninstall from the list, and double– click it to uninstall.
③
Restart Windows.
※
The Windows INBOX display driver may be installed after the restart. If restarting the system
is requested, restart the system according to the on– screen message.
[Windows 8]
①
Select[Control Panel] → [Uninstall Programs] (In Classic View, select [Control Panel] →
[Programs and Features].)
②
Select a driver you want to uninstall from the list, and double– click it to uninstall.
③
Restart Windows.
※ The Windows INBOX display driver may be installed after the restart. If restarting the system
is requested, restart the system according to the on– screen message.
(2)Make sure that the workstation is powered off, unplug the power cord, and install the Quadro
K600 in the workstation. See "2. Installing Hardware" for installation procedure.
(3)Installing Windows (If Windows is already installed, you may skip this step).
(4)Install the display driver according to "3.1 Installing Display Driver".
Take the steps above to install hardware and software.
１１