Table of Contents
Advertisement
PERLICK RESIDENTIAL UNDERCOUNTER INSTALLATION MANUAL
Changing the Lower Compartment Temperature:
1. Press and hold the SET button until the display shows St1
with"F" flashing.
2. Press SET again to display the lower compartment's current
temperature ("F" will continue to flash).
3. Use the UP or DOWN arrow key to scroll to the desired
temperature. The controller will memorize the new
temperature.
Changing the Upper Compartment Temperature:
1. Press and hold the SET button until the display shows St1
with"F" flashing. Press the DOWN arrow once; the display will
read St2.
2. Press SET again to display the upper compartment's current
temperature ("F" will continue to flash).
3. Use the UP or DOWN arrow key to scroll to the desired
temperature. The controller will memorize the new
temperature.
NOTE: Dependent on the model and configuration, the controllers have
been programmed to only allow a lower compartment temperature
adjustment range as specified within the chart below. The upper
compartment range is not limited, but should always be kept within
the specified range shown in the table for the upper compartment. See
the chart below for the specified range allowed for your unit.
Signature Series – Dual-Zone Units
Model
HP24Z
Upper 30° - 42°F / Lower -10° - 15°F
HP24C
HP24D
To Start A Manual Defrost (HP24Z Models Only)
Press and hold the DEFROST button (melting snowflake) for 3-5
seconds. Melting snowflake will illuminate.
15", 24" Single Zone, 24" Shallow Depth, and ADA Controls
To Set Target Temperature
Press and release the SET button. Display will show the current
temperature setpoint.
To Change Setpoint Temperature
1. Press and hold the SET button until the display shows the
current setpoint temperature with the "F" flashing.
2. Use the UP and DOWN arrow button to scroll to the desired
temperature.
16 | perlick.com
Range (F)
Upper 45° - 65°F / Lower 33° - 42°F
Upper 51° - 65°F / Lower 45° - 55°F
To Start A Manual Defrost (Freezer Models Only)
Press the DEFROST button (melting snowflake).
To See Maximum Stored Temperature
Press the UP arrow button to see the maximum stored
temperature. To reset the maximum stored temperature, while
displayed, press and hold the SET button until 'rst' flashes in the
display.
To See Minimum Stored Temperature
Press the DOWN arrow button to see the minimum stored
temperature. To reset the minimum stored temperature, while
displayed, press and hold the SET button until 'rst' flashes in the
display.
On/Off
Press the ON/OFF button to turn the unit on or off.
NOTE: Dependent on the model and configuration, the controllers
have been programmed to only allow a temperature adjustment
within a specified range. See the chart to right for the specified range
allowed for your unit.
Advertisement
Table of Contents
