Table of Contents
Advertisement
PERLICK RESIDENTIAL UNDERCOUNTER INSTALLATION MANUAL
SHELVING/DRAWER ADJUSTMENTS
Completely empty shelf or drawer
CAUTION
before removing.
1. Pull the shelf/drawer out to its furthest position.
Locate the tabs in the middle of both extenders. Lift
one tab up while pushing the opposite tab down,
and pull shelf/drawer out (Figure 6).
2. Position each bracket separately. Grasp the middle
of the bracket, pull the front end up and out, then
forward to remove it.
3. Place bracket at desired location. Push the bracket
rear hook into the rear mounting slot, then set front
of the bracket in the front slot.
4. Repeat for other brackets.
5. Push extenders completely into brackets. Align the
shelf/drawer grooves with the extenders and slide
completely into the unit.
Figure 6. Shelving/Drawer Adjustment
8 | perlick.com
DOOR OPTIONS
Perlick residential units offer a variety of door panel
design alternatives; solid stainless steel, solid wood
overlay, glass with stainless steel trim and glass with
wood overlay trim.
Solid stainless steel and stainless steel glass doors are
shipped from the factory with decorative stainless steel
panels and handles in place on the unit. Solid wood
overlay and glass wood overlay doors are designed to
accept a decorative front panel to match surrounding
cabinetry and door handles.
NOTE: Wood overlay models are designed to accept wood
overlay panels from your cabinetry supplier. They do not
include a wood overlay. Templates are available on www.
perlick.com/residential-products. Click on Service & Support,
and then choose Wood Overlay Templates from the menu.
Take care in choosing the correct template for your specific
model. The handle is supplied by the customer.
All Perlick units (excluding beer dispenser and ice maker
models) accept any of the above door configurations
and are fully interchangeable. Glass door configurations
are not available on beer dispenser or ice maker models.
NOTE: Glass with stainless steel trim and glass with wood trim
may sweat in conditions with relative humidity over 75%.
CHANGING DOOR SWING DIRECTION
NOTE: Changing the door mount is not advisable if the door is
equipped with a custom wood overlay. Doing so may result in
an undesirable handle position.
To change the door swing direction, a hinge kit is
required:
• Part No. 67439R - Right hinge kit
• Part No. 67439L - Left hinge kit
In addition to the hinge kit, the following tools are
required:
• Large flat head screwdriver
• Regular Phillips head screwdriver
• Plastic putty knife
1) Support the door in the open position as shown in
Fig. 7 on page 9. Remove the hinge pin.
2) Pull door to the side and then lower door.
3) Remove top and bottom hinge brackets. Retain screws
for later use. See Fig. 8 on page 9.
4) Remove the hole plugs from the top and bottom
hinge bracket mounting holes (see Fig. 8 on page 9).
Place the plugs in the holes on the opposite side made
vacant by removing the hinges in step 3.
Advertisement
Table of Contents
