Display Settings - Igo DISCOVERY ROSEMONT LE1 Owner's Manual

8
iGO DRIVE
Display mode
After switching on the eBike, the bottom left segment on the display will show the Odometer.
Short press the POWER BUTTON to toggle through the following display modes :
odometer | maximum speed | average speed | trip time
ODOMETER
AVERAGE SPEED
Settings menus
With the display on, press and hold the PLUS (+) and MINUS (-)
buttons simultaneously to access the settings menus.
use the PLUS (+) or MINUS (-) buttons to toggle through the listed options.
Short press the POWER BUTTON to select the hi-lighted option.
SETTING

Display Settings

Advanced Settings
EXIT
Note :
Settings can only be changed when the eBike is safely parked and not moving.
MAX. SPEED
TRIP TIME
DISPLAY SETTINGS
use the PLUS (+) or MINUS (-) buttons to toggle through the list options.
Short press the POWER BUTTON to select the hi-lighted option.
use the PLUS (+) or MINUS (-) buttons to toggle through the selected option's values.
Short press the POWER BUTTON to confirm and save the hi-lighted value.
Display Setting
TRIP Reset NO
Toggle Unit Metric
Wheel 27.5 inch
Speed Limit 17Km/h
Set Voltage 36V
SOC View Percent
BACK
Trip Reset
YES : Clear the trip odometer (single ride) distance value.
NO : cancel the trip reset and return to the option list.
Toggle Unit
Metric : set distance and speed to display in kilometers (km/h).
Imperial : set distance and speed to display in miles (MPH).
Wheel
Set the wheel diameter value. The default value should be the correct value
for your bike. Changing to a different value that does not match actual wheel
diameter may cause distance and speed values to display incorrectly.
Speed Limit
Changing from the default may only affect the speed indicated
on the display. This will NOT affect the assist speed.
Set Voltage
Set displayed battery voltage values. The default value should be the correct value
for your bike. If you are unsure the value set is correct contact iGO support.
1 : 31.6
2 : 34.6
3 : 35.6
4 : 37.4
5 : 39.2
SOC View (battery State of Charge)
01 : Display battery State of Charge as a percentage (%)
02 : Display battery State of Charge as voltage (V).
Back
Return to the previous menu.
9