Table of Contents
Advertisement
16
iGO DRIVE
REMOVE / INSTALL BATTERY
To remove the battery from the bike frame first remove the battery
cover under the battery tube by pushing down on the top latch and
tipping the top edge down on an angle, then lift and remove.
Insert the key into the lock but do not turn at this time. Support the battery with one
hand & use the other to turn the key 90˚ clockwise to the unlock position. While holding
the battery parallel to the frame carefully allow the battery to drop out of the frame.
To reinstall the battery, insert the key into the battery lock but do not turn at this time. Hold
battery parallel to frame and line up the battery with the receptacle. Insert the bottom portion
of the battery first, and then with one hand turn the key 90˚ counter clockwise to the unlock
position. Push the top part of the battery into the receptacle until you hear the latch close
onto the battery. At this point the battery will hold itself in place. With both hands on each side
of the frame and thumbs under the battery case push the battery to make sure its locked and
secure.
Reinstall the battery cover by inserting the tab on the bottom part of the battery cover into the
slot located under the battery. Once inserted tilt the cover and latch into place.
Always lock battery & remove the key while riding.
REMOVE BATTERY COVER
SUPPORT BATTERY AND TURN KEY
INSERT KEY
CAUTION
When the key is turned the battery lock
will be released. The battery must be
supported to avoid falling from the frame.
CHARGING THE BATTERY
The battery can be charged both on and off of the bike.
It is important to follow these charging instructions in order :
1.
Plug the chargers male plug into the battery/bike charging port.
2. Plug the charger into an approved 110 volt outlet.
DO NOT USE A POWER EXTENSION CABLE
The indicator LED on the charger will light green for a few seconds
and if a charge is necessary, the LED will turn red. The battery is fully
charged when the battery indicator LED becomes green.
When charging is complete :
1.
Unplug the charger from the outlet first.
2. Unplug the charger from the battery/bike.
YOU MUST ALWAYS CHARGE YOUR BATTERY WITH THE SUPPLIED
BATTERY CHARGER. FAILURE TO DO SO MAY RESULT IN FIRE, PERSONAL
HARM, DAMAGE TO PROPERTY YOUR BATTERY OR eBIKE
When the battery has become completely depleted you must charge it immediately. If the
cells are left depleted for a long period of time, they may become irreparably damaged.
Make sure to only charge the battery in a dry, well ventilated area.
Unplug the charger when the battery is fully charged, or when charger is not in use.
Do not throw an expired battery in the trash. Please recycle your
battery at an authorized recycling company in your area.
PLUG IN
2
1
UNPLUG
1
2
17
Advertisement
Table of Contents
