Removing The Throttle; Battery; Identify The Battery - Igo DISCOVERY ROSEMONT LE1 Owner's Manual

14
iGO DRIVE

REMOVING THE THROTTLE

The throttle can easily be removed from the eBike if required
for Class 1 riding by following these steps :
Locate the throttle weatherproof twist connector (orange connection).
Unscrew the twist connect and gently pull to disconnect the throttle cable.
Loosen the securing bolt located under the throttle using a 3mm Allen key.
(Loosen the bolt enough to be able to freely manipulate the throttle
but not so much that the bolt falls out of the housing).
The handlebar grip will need to be removed in order to slide the throttle assembly off the end
of the handlebar. Ensure that the grip is reinstalled securely as an important safety precaution.
To re-install the throttle, repeat these steps in reverse while taking care to
properly line up the pins in the connection before applying any pressure.

BATTERY

All iGO batteries are secured to the bike frame using a barrel lock mechanism. The
battery can be removed from the frame for charging, storage, or when leaving the
bike in a public area by using the keys provided with the bike. Keys should always
be removed from the bike before riding. KEEP YOUR KEYS IN A SAFE PLACE.
It is advisable to keep a note of your key number with this manual for future reference.
The key number can be found on a metal tag attached with the keyring.

IDENTIFY THE BATTERY

The battery for the Discovery and Outland eBikes has the following features :
POWER METER
CHARGING PORT
On frame battery charging port
The frame charging port is located on the top left side of the down tube (non-drive side).
Lift the charger port cover to gain access to the port to charge
the battery when it is installed in the bike.
15
POWER METER BUTTON