Table of Contents
Advertisement
6
iGO DRIVE
ABOUT iGO DRIVE
Each iGO Drive system has been developed and custom configured for optimal
performance within the defined parameters of each eBike. The systems are :
LE DRIVE : Smooth, simple, dependable for consistent and effortless control. 32 pulse
electronic cadence sensor. Geared rear hub motor. 500W | 48V | up to 55Nm torque.
Drive system custom configured for leisure focused riding.
LS DRIVE : Intuitive natural ride experience for energetic active transport.
Dynamic mid motor system with torque, cadence, and speed sensor. 350W |
48V | up to 100Nm torque. Drive system features city tuned configuration.
RS DRIVE : Powerful, exciting, and sport performance delivering a natural ride experience on
or off road. High output dynamic mid motor system with torque, cadence, and speed sensor.
500W | 48V | up to 130Nm torque.
Drive systems are custom configured for each application
(all-road tuned/cross-country tuned).
Each utilizes an advanced electric system to offer efficiency in performance, system
information, and safety when in use or during storage. Connection to the peripheral
components is by quick secure weatherproof connectors, allowing for simple maintenance
and customization. The primary control unit and cyclocomputer interface is attached to the
eBike handlebar for quick access to settings, system information, and diagnostic tools.
MULTI CLASS SWITCHABLE
These iGO Drive systems are programmed to be 'multi class switchable' allowing parameters
to be instantly reconfigured at the touch of a button to conform to Class 1, 2, or 3 regulations.
Throttle thumb controls on iGO eBikes function when in Class 2 and 3, and are fully
disabled in Class 1. The throttle can easily be removed from the eBike when not required.
DISPLAY AND FUNCTIONS
The battery must be installed in the electric bike for the display to function.
Make sure that the battery is securely locked into the bike prior to riding.
It is recommended to remove and securely store the key when you are riding your electric bike.
The display unit houses controls for the electric systems of the
iGO eBikes and is also the cyclocomputer interface.
MOTOR POWER
LIGHT ON/OFF
PLUS (+)
POWER BUTTON
MINUS (-)
MODE
option & value
OPERATING THE DISPLAY UNIT
Power on/off
Turn the power on or off by pressing and holding the POWER button
for 3 seconds. The power will automatically turn off after the bike is
inactive for approximately 10 minutes to conserve energy.
Change PAS level
Short press the PLUS (+) or MINUS (-) button to switch between PAS levels. When
power is turned on, your iGO eBike will start in PAS '0' as a safety precaution.
In this state no power is provided to the throttle or to the pedal assist.
Lights and display backlight on/off
To turn the display backlight (and any installed headlight/rear light)
on or off press & hold the PLUS (+) button for 2 seconds.
Walk assist
Press & hold the MINUS (-) button to engage walk assist.
Release the MINUS (-) button to disengage walk assist.
Note : If a diagnostic (warning/error) icon and code appears on the eBike's
display unit, check the table on page 31 and take the appropriate action.
SPEEDOMETER
BATTERY CHARGE
TRIP ODOMETER
PAS LEVEL
and walk mode indication
7
Advertisement
Table of Contents
