Figure 17. Disconnect EDP cable and antenna cable
Step 4.
Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove six screws and then remove the LCD module.
Figure 18. Remove the LCD module
Screw specifications
M2.5 x L4.5
Remove the upper case
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the battery pack" on page 31
"Remove the speaker" on page 32
"Remove the Wi-Fi card" on page 32
"Remove the I/O board cable" on page 33
"Remove the I/O board" on page 34
38
Hardware Maintenance Manual
Number of screws
6